NewStats: 3,263,738 , 8,181,205 topics. Date: Saturday, 07 June 2025 at 03:59 PM 3ri2q

cyif2003:


U have an idea of the cost? Also driving the car like this will it cause any immediate damage ?

I don't know how much it costs now. It will be a bit pricey with the high dollar rate now.

Also, driving the car like that won't cause any damage. As long as you can bear that annoying sound for just those few seconds.

remi4ever:
@gazzuzz

Hello sir. I have been battling with this u0107 throttle actuator control module error. This happens only in the evening when the car has sit under the sun for a long time. I have changed the "injector mouth". My Rewire has checked the wiring.

PS, only happens when car is hot. Doesn't happen in the morning.

Possibly moisture condensation. I would check the engine ecu

@gazzuzz


On my Hyundai Accent 2012 1.6L engine, high RPM is 1500 in the morning and I rarely have time to see if it will adjust but when I put the AC ON and Drive, RPM is 1000 and also acceleration is sticky but when I'm about to apply brake it jerks like is about to speed up.

then in the afternoon under hot sun RPM is below 800, idling is not steady going up and doing and also vibrate with Ac ON


Only error code is P0030 and that's H02S bank 1 sensor1


Good morning sir, please help me

Olyquezyy:
@gazzuzz


On my Hyundai Accent 2012 1.6L engine, high RPM is 1500 in the morning and I rarely have time to see if it will adjust but when I put the AC ON and Drive, RPM is 1000 and also acceleration is sticky but when I'm about to apply brake it jerks like is about to speed up.

then in the afternoon under hot sun RPM is below 800, idling is not steady going up and doing and also vibrate with Ac ON


Only error code is P0030 and that's H02S bank 1 sensor1


Good morning sir, please help me

Vehicle struggling to achieve close loop situation.
Replace oxygen sensor.

So I have a Hyundai sante fe 2007 3.3ltrs engine.
Each time I accelerate to 20km/HR or more, I get a lot of vibrations on the car,felt strongly at the steering.
The vibrations reduces at higher speeds.
And also wen I carry engers/loads, any small pothole or rough road I enter, it will seem as if the car isn't balanced anymore and tilts towards that direction a bit.

Any help from d house?🙏

Victorprofan:
So I have a Hyundai sante fe 2007 3.3ltrs engine.
Each time I accelerate to 20km/HR or more, I get a lot of vibrations on the car,felt strongly at the steering.
The vibrations reduces at higher speeds.
And also wen I carry engers/loads, any small pothole or rough road I enter, it will seem as if the car isn't balanced anymore and tilts towards that direction a bit.

Any help from d house?🙏

Physical inspection and diagnosis would help pinpoint what's wrong with the vehicle.
Where's your location?

jceesquare:

Physical inspection and diagnosis would help pinpoint what's wrong with the vehicle.
Where's your location?

Abeokuta/sagamu Ogun state axis.

Hey!!!
I'm in trouble oo.
I took my 08 es350 to a mechanic a friend recommended for shockpad change
I instructed he also changed the powersteering fluid as I noticed it gets a faint whinny sound when I drive for long... We went to drink beer, only to come back and this mechanic poured visco2000 into my powersteering reservoir. Saying it's good and works well.

Abeg what do I do now? I've driven it for 2 days now but I'm worried

Please who knows a good mechanic at gbagada that can do cv t replacement. thank you

@gazzuzz or any experience Oga in the house..


Hello Sir,
Please my 2008 rav4 recently suffered from electrical issues.
Car went off and refused to start at an unsafe location. In order to free up the transmission to move vehicle to safety, I noticed the rewire inserted a screwdriver into the hole at the selector and moved it to neutral. Car was then rolled to safety where efforts were made to trace the problem.

ECU was detected as the cause. It has been changed and car starts and drive now.

Problem now is that, when I select reverse(R) or drive (D), it enters with a gentle bang.
But when driving, the other gears select quietly as before.
Putting it in R or D has always been very smooth without bang before now.

The brake light has also refused to go off.

No transmission code on Bluetooth scanner.

Could it have anything to do with the changed ECU or the rewire has touch something else?

What can I do to have that smooth bang-free experience again, please

Good morning everyone.
I own a Camry 2008.
It has a fuel tank size of 70L.
I noticed it consumes too much fuel.

On a full tank till the amber fuel light, it did about 190 miles and that’s like 11 mpg compared to the 25mpg -30mpg as recorded by Toyota.


I have no check engine light
Spark plugs intact
02 sensors working too.
Catalyst intact too.


What could be the problem?
This worries me a lot.


I await your response 🙏🏾

GAZZUZZ:


Vacuum line installed wrongly

please I need 1.5hp AC My friend in Ogba once bought from you. Anymore still available??

Olyquezyy:
@gazzuzz


On my Hyundai Accent 2012 1.6L engine, high RPM is 1500 in the morning and I rarely have time to see if it will adjust but when I put the AC ON and Drive, RPM is 1000 and also acceleration is sticky but when I'm about to apply brake it jerks like is about to speed up.

then in the afternoon under hot sun RPM is below 800, idling is not steady going up and doing and also vibrate with Ac ON


Only error code is P0030 and that's H02S bank 1 sensor1


Good morning sir, please help me

Tuned to operate this way by your ac technician who modified the system.

#abuse

Victorprofan:
So I have a Hyundai sante fe 2007 3.3ltrs engine.
Each time I accelerate to 20km/HR or more, I get a lot of vibrations on the car,felt strongly at the steering.
The vibrations reduces at higher speeds.
And also wen I carry engers/loads, any small pothole or rough road I enter, it will seem as if the car isn't balanced anymore and tilts towards that direction a bit.

Any help from d house?🙏

Ball ts and lower control arms

Good evening to all the ogas in the house. Please wo can help on what to do on a 2006 toyota sienna AC that cools chills on the 2 engervents but blows normal air on the driverside vents and the back? Compressors have been changed, expansion valves for both the front and back has been changed also to no avail. Don't know what else to do as the system keeps draining money.
Gazzuzz
Nurey
Kingreign

Elcapitan0:
Good evening to all the ogas in the house. Please wo can help on what to do on a 2006 toyota sienna AC that cools chills on the 2 engervents but blows normal air on the driverside vents and the back? Compressors have been changed, expansion valves for both the front and back has been changed also to no avail. Don't know what else to do as the system keeps draining money.

You didn't indicate if yours has dual climate control settings.
While changing the expansion valves, did you check the switching valves to know if its stuck in one position?

jceesquare:

You didn't indicate if yours has dual climate control settings.
While changing the expansion valves, did you check the switching valves to know if its stuck in one position?

It does not have dual zone climate control. I was telling the technician that the one removed has no difference with the one they brought with the method they are using (blowing into it to check for restrictions) but they said they'll change it and i just let them and it didn't get better.

Hello house
@GAZZUZZ

Please help.
I just brought a toyata camry 2008 and have been using it for a month now, i changed the old when i brought it as nigeria used,

I have my check engine light on since i brought it and a tapping sound which my mechanic said they are not serious issues,

I noticed this morning that my check engine light kept blinking non stop, its was stable before but now its always blinking, my mechanic said its not issue but im scaried cos what i read about check engine light is scary

Please help.

sholamat:
Hello house
@GAZZUZZ

Please help.
I just brought a toyata camry 2008 and have been using it for a month now, i changed the old when i brought it as nigeria used,

I have my check engine light on since i brought it and a tapping sound which my mechanic said they are not serious issues,

I noticed this morning that my check engine light kept blinking non stop, its was stable before but now its always blinking, my mechanic said its not issue but im scaried cos what i read about check engine light is scary

Please help.

Engine misfire . You need to scan

sholamat:
Hello house
@GAZZUZZ

Please help.
I just brought a toyata camry 2008 and have been using it for a month now, i changed the old when i brought it as nigeria used,

I have my check engine light on since i brought it and a tapping sound which my mechanic said they are not serious issues,

I noticed this morning that my check engine light kept blinking non stop, its was stable before but now its always blinking, my mechanic said its not issue but im scaried cos what i read about check engine light is scary

Please help.

Misfiring issue.
This is an issue relating to bad coils.
Get a rewire to scan it for you to detect the faulty/bad ones.
Plugs would have been affected, too.
Just do the scanning, it will display the issues to you.

Much respect, sir.

Glithronix:

Misfiring issue.
This is an issue relating to bad coils.
Get a rewire to scan it for you to detect the faulty/bad ones.
Plugs would have been affected, too.
Just do the scanning, it will display the issues to you.

Much respect, sir.

Thanks sir.
I dont know anyone that can help me scan around, but i will keep asking,

sholamat:


Thanks sir.
I dont know anyone that can help me scan around, but i will keep asking,

No let anyhow person do the scanning for you.
He must be a professional rewire.

Alright, boss.

Glithronix:

No let anyhow person do the scanning for you.
He must be a professional rewire.

Alright, boss.

Ok sir. Thanks so much

Good morning bosses into the house. I've had a check engine light on my lexus es350 2013 for while now and I've been driving it that way because all the essentials are working. However I scanned it days ago and I got these code p0300, P2240, p2241. The last two are related to o2 sensors. I noticed the car guzzles fuel alot 15mpg on average.

I suspect there's no cat on the car, I don't Intend to buy a new one, I just want to get rid of the code , I don't know if a spacer can work for a 2013 car, that's my goto option at the moment. I'm open to suggestions

@Gazzuz and others.
Pls i want the right transmission fluid to use for sequoia 2004.
Mechanic said Dexron II, Fuel station said i should use dexron III.
Which one is best and ok for the vehicle
Secondly i want to change my power steering oil, advise the right fluid.
Thanks

Freetech:
@Gazzuz and others.

Pls i want the right transmission fluid to use for sequoia 2004.

Mechanic said Dexron II, Fuel station said i should use dexron III.

Which one is best and ok for the vehicle

Secondly i want to change my power steering oil, advise the right fluid.

Thanks

Check your dipstick, the correct oil is written on it. Same with the power steering too, check the reservoir cap

Hello @Gazzuzz and house,

Due to wear and low ground clearance ,I'm looking to change tires on Kia Rio 2016 EX trim.. seller sold it with mixture of 195/65/15 91T and 195/60/15 88H.

Which size do you advise? Thank you.

sucobaba:
Hello @Gazz.uzz and house,

Due to wear and low ground clearance ,I'm looking to change tires on Kia Rio 2016 EX trim.. seller sold it with mixture of 195/65/15 91T and 195/60/15 88H.

Which size do you advise? Thank you.

195/65/15 too small. 15" rim is not vey good for this Nigeria roads, except is covered with 70' profile (vertical height) tyre.
205/65/16.
I don't think that car leg space can take beyond that self.
So, with 205/65/16, you would appreciate the difference.

Much respect, sir.

Glithronix:

195/65/15 too small. 15" rim is not vey good for this Nigeria roads, except is covered with 70' profile (vertical height) tyre.
205/65/16.
I don't think that car leg space can take beyond that self.
So, with 205/65/16, you would appreciate the difference.

Much respect, sir.

Thank you, appreciate your contribution. Any tire brand you'd recommend?

sucobaba:
Hello @Gazzuzz and house,

Due to wear and low ground clearance ,I'm looking to change tires on Kia Rio 2016 EX trim.. seller sold it with mixture of 195/65/15 91T and 195/60/15 88H.

Which size do you advise ? Thank you.

[quote author=GAZZUZZ post=129804192][/quote]
Thank you, any reason(s) for the bolded?

Appreciate your time.

Good day Gazzuzz and bosses in the house, I wanna get a naija used Lexus ES350 2008-2011 or a naija used Hyundai Sonata 2012/2013 please which is a better buy?